|
.............................................................................. |
Micro Pure Water Filtration, Inc.

Micron
Disposable Filters
High Efficiency
Filters
Pre-Filters

|
Please browse through this page for information on the selected topic
or source. Additional information and details are available on
the Micro Pure Water Filtration Inc. website .
Click here:
www.micropure.ca |

|
 |
Micron high efficiency
cartridges can last 3 months and will remove a wide range of
contaminants, while reducing or eliminating the need for many types of
chemicals. Get better water quality with less effort and more
consistency. |
|
What Micron Disposable Filters Can Offer That Cartridges Can Not |
- No filter cleaning needed with costly and dangerous filter cleaners.
- Lower density at the surface of the filter with progressively higher density towards the center.
- Particles are trapped throughout the entire cross section of the filter, creating superior dirt-holding capacity.
- Patented thermally-bonded blown microfibre process assures
consistent performance, filter change to filter change.
- No leachables or extractibles, the filter holds onto
everything that it removes.
- Inert material means broad chemical compatibility.
- Lower maintenance time and costs.
- Longer Optimum Filter Life Expectancy.
|
|
Increased Filtration - Better Water
Quality |
- Filters faster and more efficiently than any other spa filter on the market.
- Quicker water recovery after heavy use, takes contaminants out of
the water before they build-up and cause a decrease in sanitizer
levels.
- Lasts 2 -3 times longer than your standard cartridge filter
- Eliminates the need for Defoamers, Clarifiers, Cleaners, Enzymes and
Scum Removal Products.
- Chemicals last longer with less contaminants in the
water.
- Fewer chemical problems and longer water life.
- Removes solids in water and lowers the TDS on a
continuous basis.
- Takes out minerals, stopping buildup on
the equipment and heater, extending the life of the equipment.
|
|
Why Fill A
Pool or Spa With Dirty Water? |
 |
The water used to fill a
spa or pool is not as pure as you may think. Especially, if well water
is being used!!! There are impurities, such as, copper, iron,
calcium and other deposits that can be harmful
to yourself, your family and your spa. Using clarifiers, coagulants,
flocculants and, stain and scale preventers will reduce these
impurities, but will not eliminate the problem. You can reduce the total
dissolved solids (TDS) problem and increase the life & quality of your
spa water, by using the Micron Pre-Filter. This
allows the consumer to enjoy a spa using water with filtration
down to 1 micron. The human eye can detect to 40 microns. Blood cells
are approximately 2 microns. The Micron Pre-Filter is 90% efficient and
allows the main filter to operate longer and with greater results.
Attach the Micron Pre-Filter on the end of a regular
garden hose and begin the fill. Easy!!! |

Micro Pure Water Filtration Inc.
10846 170 St.
Edmonton, Alberta, Canada T5S 2H7
(780) 452-1577 ●
(780) 452-5509
www.micropure.ca

▲
Return To Top Of Page
▲
We hope that you found
AskAlanAQuestion.Com helpful!!! The support of
the affiliated companies makes this pool & spa resource possible.
Aqualab Systems.,
Inc. does not make any warranty or representation, either expressed or implied, regarding
the accuracy or completeness of the information provided by this website; nor does Aqualab
Systems., Inc. assume any liability of any kind whatsoever related to, or resulting from,
any use or reliance on this information. The content of this website
should not be used, if it is conflict with any applicable federal, state or
local regulations or guidelines.
©,
2002-8,
A.S., Inc. All rights reserved.
|